High-strength three-component epoxy mortar for repairs.

Application of SpECbuild EM
Preparation:
It is essential that adequate surface preparation is carried out prior to the application of SpECbuild EM. Grit blasting is recommended to ensure the removal of all laitance, grease, and oil. The resulting surface should be dry and dust-free. The repair boundary should be cut back to a depth of at least 10mm to avoid feather edging. All corroded steel should be completely exposed, including the rear of the bar to enable thorough cleaning. The steel should be cleaned to bright metal immediately prior to the application of SpECcoat Zn25 zinc-rich protective coating. Apply one coat of SpECcoat Zn25 to the cleaned steel ensuring full coverage, and allow to dry before commencing the next step.
Priming:
The prepared surface should be primed with SpECtop Primer F1. The mixed primer should then be applied to the prepared substrate by a stiff brush at a coverage rate of 10-15m²/litre. If the primer appears to be absorbed into the surface easily, it will be necessary to apply a second coat once the initial coat is tack-free. Allow the primer to become tacky prior to the application of SpECbuild EM.
Mixing:
SpECbuild EM is supplied as a three-component kit consisting of a base component, a curing agent, and a bag of selected, graded aggregate. The two resin components should be stirred separately before mixing the two together to achieve a homogeneous consistency. The entire quantity of resin is placed into an appropriately sized forced action mixer, and the aggregate is slowly added to the resin with the mixer running. Continue to mix for a further 3 to 5 minutes until all components are thoroughly blended. The mixing of part packs should not be undertaken.
Application:
Apply the mixed product firmly onto the tacky primer using a trowel to build the required thickness. Use a wooden float to ensure complete compaction and a secure bond. Where access to the substrate is difficult, such as around steel reinforcement, a gloved hand may be used for placing. The application is always completed by closing the surface of the mortar with a steel trowel before it sets. Subsequent layers should be applied within 10-12 hours. If this time is exceeded, the surface should be reprimed prior to succeeding applications.
Overcoating:
Where SpECbuild EM is used in a hygienic situation, it may be overcoated with a suitable epoxy resin coating such as SpECtop ARE125.